WHITE CEMENT BASED MODIFIED POLYMER TILE ADHESIVE
Tile Adhesive Cementitious complies to the adhesion requirements of IS 15477: 2019 Type 3T “Specification for Adhesives for use with Ceramic Tiles.” Also complies with EN C2TE Classification.
Colour : White
Working Properties at 21° C
REYNOSTYLE TAC 3T 325 W Adhesive mixed with Water
| Open Time | 20 minutes |
| Pot Life | 3 – 4 hours |
| Adjustment Time | 20 Minutes |
| Time to Heavy Traffic | 16 – 24 hours |
Available in – Packaging : 20 kg bags
FAB ( Features, Benefits & Advantages )
• White high polymer modified cement-based wall & floor tile adhesive. Suitable for fixing marble, tiles and
natural stones in interior and exterior situations, including swimming pools and other wet areas due to
good underwater shear-bond
• For installation of ceramic / clay / vitrified / basalt / glass mosaic and porcelain / all natural stone tiles with
porosity less than or equal to 3 percent
• Can also be used as slurry bond adhesive in wet-on-wet applications, tile on tile applications
• For installation of large dimensions not greater than 1000mm x 1000 mm on wall substrates like plaster or
concrete
• To install tiles on to various substrates like Concrete: Concrete Masonry, VDF / Trimix Concrete, Cement
Mortar Beds, Cement Plaster; Existing Vitrified Tile & Ceramic Tile; Brick Masonry; Cement Terrazzo;
Existing Natural Stone, Cement Backer Board, Calcium Silicate Board, Gypsum Wallboard
Coverage
Approx. 50 to 55 sq. ft. per 20 Kg pack, using 6mm x 6mm square notched trowel for a bed of 3mm. Coverage
will depend on the nature and flatness of the surface and the method of application. For good coverage, it is
must that all surfaces are smooth, plumb, level and free from defects and undulations.
Mixing
– Add Tile Adhesive to clean water.
– Mix thoroughly by hand or with a slow speed mixer to obtain slump free mortar for a trowel able
consistency.
– Use approximately 5 litres of water for 20 kg of powder.
– The adhesive is immediately ready-for-use and has a pot life of 2.0 hours.
– No further water should be added.
– Allow adhesive to slake for 5 minutes.
Note: Addition of REYNOBOND Latex partially or completely replacing water increases the bond strength and
flexibility of mortar
TECHNICAL DATA
| IS Data | ||
| Property: Test method | Requirement | Typical Values |
| Tensile Adhesion | ||
Dry Conditions – Annex A (Clause5.1) | Minimum 1.5 N/mm² | 1.5-1.65 N/mm² |
Wet Conditions – Annex A (Clause5.1) | Minimum 1.00 N/mm² | 1.10-1.20 N/mm² |
| Shear Adhesion | ||
Dry Conditions – Annex B (Clause 5.2) | Minimum 1.5 N/mm² | 1.60-1.70 N/mm² |
Heat Ageing – Annex B (Clause 5.2) | Minimum 1.00 N/mm² | 1.10-1.20 N/mm² |
Wet Conditions – Annex B (Clause 5.2) | Minimum 1.00 N/mm² | 1.15-1.25 N/mm² |
Slip resistance- Annex E (Clause 5.5) | ≤ 0.5 mm | 0.35-0.45 mm |
* For further detail, Please refer to Technical Data Sheet
