REYNOSTYLE TAC 1T 305

GENERAL PURPOSE TILE ADHESIVE FOR INTERNAL USE

Tile Adhesive Cementitious complies to the adhesion requirements of IS 15477: 2019 Type 1 “Specification for Adhesives for use with Ceramic Tiles.” Also complies with EN C1 Classification

Colour : Grey

Working Properties at 21° C

REYNOSTYLE TAC 1T 305 Adhesive mixed with Water

Pot Life 2 Hours’
Time To Heavy Traffic 16 – 24 hours

Product Description

FAB ( Features, Benefits & Advantages )

• High performance polymer modified cement adhesive
• Easy to mix with water & easy application process
• Single component, cement based thin set tile adhesives for internal dry area
• For installation of tiles on floors and walls up to 3 meters.
• To install clay and ceramic tiles with porosity greater than 3%
• For installation of tile size not greater than 300mm x 300mm
• To install tiles on cement-based substrates like cement plaster, cement concrete, cement screed etc.

Coverage
Approx. 50 to 55 sq.ft. per 20 Kg pack, using 6mm x 6mm square notched trowel for a bed of 3mm. Coverage
will depend on the nature and flatness of the surface and the method of application. For good coverage, it is
must that all surfaces are smooth, plumb, level and free from defects and undulations.

Mixing

– Add Tile Adhesive to clean water.
– Mix thoroughly by hand or with a slow speed mixer to obtain slump free mortar for a trowelable consistency
– Use approximately 5 litres of water for 20 kg of powder.
– The adhesive is immediately ready-for-use and has a pot life of 2.0 hours.
– No further water should be added.
– Allow adhesive to slake for 5 minutes.

Note: Addition of REYNOBOND Latex partially or completely replacing water increases the bond strength and flexibility of mortar